Electric Pressure Cooker Hard Boiled Eggs (No-Peel) - Recipes That Crock! (2024)

FAQs

Why do my eggs crack in the pressure cooker? ›

There are a few theories for why this is. Some say that, similar to steaming eggs, the pressure cooker forces steam inside the egg's shell during cooking, causing it to separate from the egg white. Alton Brown's theory is that it's more about the rapid temperature change inside the sealed pot.

Pressure cooker hard-boiled eggs aren't any quicker to make (the pressure cooker's usual claim to fame), but here's why it's great: it actually makes fresh eggs easy to peel! If you happen to raise chickens or have access to really fresh eggs, a pressure cooker is the best way to make hard-cooked eggs.

Eggs can break during boiling because of numerous reasons. The most common reason is that they were boiled at an intensity so high that they collided with each other or the pan, resulting in cracks. However, this is rarely seen in eggs from organically-fed chicken because they produce hard shelled eggs.

The average load to break the eggs when standing up was 53 Lbs. On their side, an average of 90 Lbs was required. This makes sense because eggs are flatter on their side, which allows more of the platen/foam to contact the shell, helping distribute the force across a larger area.

Here's why: The vinegar's acid not only dissolves some of the calcium carbonate in the shell, it also helps the whites set faster. Running the hard-boiled eggs under cold running water as you're peeling, meanwhile, helps the shell separate from the membrane.

Here's her hack for how to peel hard-boiled eggs in large batches: Put five thoroughly cooled hard-boiled eggs into a small plastic container with some cold water, top with the lid and then gently rock and shake until the shells break and fall away. You'll almost always end up with perfectly peeled eggs.

Hard-cooked eggs may be difficult to peel if they are very fresh. This is because an egg shrinks inside during storage, which pulls the inner membrane away from the inside of the shell. For this reason, a hard-cooked egg will peel more easily if it has been stored for 1 or 2 weeks before it is cooked.

To make a larger batch of hard-boiled eggs, use a large pot--large enough so that the eggs are in a single layer. Cover the (room temperature) eggs with cool to lukewarm water. Bring the water to a boil, then cover the pot and remove it from the heat and wait 12 minutes.

Simply fill a bowl with cold tap water and place your eggs in it. If they sink to the bottom and lay flat on one side, they are fresh and good to eat. A bad egg will float because of the large air cell that forms at its base. Any floating eggs should be thrown out.

Once all the water is gone, a cute jingle will play to alert you that your eggs are done. After that, I tend to plunge them into ice water to prevent them from overcooking, but that's not a necessary step.

How much pressure can an egg take vertically? ›

Testing by SPS found a wide range of maximum loads from ~100 lb to some as high as +300 lbs for standard, large eggs. Explain to the audience that the reason the egg can withstand such forces is because the foam decreases the pressure the egg experiences.